Speeduino также поддерживает считывание до 16 дополнительных входных каналов. Эти входы могут быть либо аналоговыми, либо цифровыми контактами на Mega2560 (или других используемых mcu), либо от удаленного устройства передачи данных (например, DxControl GPIO) через вторичный последовательный порт или интерфейс Canbus (если имеется).
Канал данных, сконфигурированный здесь, будет иметь необработанные данные, доступные в TunerStudio в качестве датчика, и также будет регистрироваться.
The configuration is mainly split into two categories,
The configuration page is accessed from the Accessories drop down within TunerStudio ,select the "local Auxillary input channel configuration" option
This window will be opened.
In the above image the first two channels have been configured as an local analog and a local digital input respectively.
The input alias can be any ascii character name the user wishes up to 20 characters long. This can also be left as the default .
Options here are
(this option is only visible if CAN_COMMANDS is enabled in project properties.See here for further information
This setting is only available for local mcu pin selections. It is the actual mcu pin name.
To use the Auxillary input channels for external data the Secondary IO must be enabled. See here for further information on how to do this.
The configuration page is accessed from the Accessories drop down within TunerStudio ,select the "External Auxillary input channel configuration" option
This window will be opened.
For External data inputs to be active the "Enable External Data Input" option must be enabled.
In the above image the first three channels have been configured as an local analog and a local digital input and a External input respectively.
The input alias can be any ascii character name the user wishes up to 20 characters long. This can also be left as the default .
Options here are
This is the Hex address of the remote Device
A can data command has up to 8 bytes. This value sets the first data byte the data value begins at.
The data byte can be made from a single byte or two (word or 16bit value)